1. DIAMETER -- Specify required outside or Inside Diameter of Screen Section in inches. (See Illustration below.)
2. LENGTH -- Specify required length of Section in inches. (See Illustration below.)
3. SEGMENTS -- If segments are required, specify number of segments to each section and length. Also advise if butt or lap joints required.
4. ARRANGEMENT OF PERFORATIONS -- Staggered against flow is standard, advise if otherwise. (Note: Flow is considered parallel to circumference of screen section.)

HAMMER MILL SCREENS

1. Width
2. Length
3. Chord
• Opening Size
• Opening Spacing (Hole center)
• Material -- HR, S/Steel, Etc.
• Material Thickness
• Dimension of Blank Margins, If Required
• Blank Margins (usually not required), Additional Cost If Margins Are Required