DIAMETER -- Specify required outside or Inside Diameter
of Screen Section in inches. (See Illustration below.)
LENGTH -- Specify required length of Section in inches.
(See Illustration below.)
SEGMENTS -- If segments are required, specify number
of segments to each section and length. Also advise if
butt or lap joints required.
ARRANGEMENT
OF PERFORATIONS -- Staggered against flow is standard,
advise if otherwise. (Note: Flow is considered parallel
to circumference of screen section.)
HAMMER
MILL SCREENS
To
order, list the following:
Width
Length
Chord
Opening
Size
Opening
Spacing (Hole center)
Material
-- HR, S/Steel, Etc.
Material
Thickness
Dimension
of Blank Margins, If Required
Blank
Margins (usually not required), Additional Cost If Margins
Are Required
San
Francisco
1530 17th St.
San Francisco, CA
(800) 726-9473
Fax (415) 863-2635
Signal
Hill
1166 E 23rd St
Signal Hill, CA
(800) 733-3378
Fax (562) 492-6932
