Poly-Clean L

• Designed to withstand heavier
  loads yet still provide excellent
  cleaning action.
• Straight wires maintain tension while the crimped wires vibrate independently.
• Needs impact from above to fully engage cleaning action
  - 25% of feed size 4 times the
  opening.
  Best suited ½”-1”

Poly-Clean T

• Rapid removal of fine material
• Ideal for bottom deck screening on mobile plants- REPLACE HARP SCREEN
  - Powerscreen
  - Extex
  - ©Metso
  - Can be re-installed easier than speed harps.
  Commonly ¾” and below
• Unlike Harp screens it can be
  installed on sided tension decks

Poly-Clean S

• No straight wire
• Fine openings and large openings
  - 3/32” – ½”, 1” and above.
  • Applications dictate that
  Poly-Clean L is more
  common in the ½” to 1”.
• Good sizing accuracy

Poly-Clean H

• Accurate sizing – but not as good as S
• Good cleaning ability
• High open area
• Mainly used in finer
  openings 3/4” and below
• Replace Harp & slotted
  screens for a more
  accurate separation

• Laps are recommended on
  openings 3/8” and below
  - Unlike regular wire cloth the
  lap should be installed down
  hill
• Side laps can be added to end
  tensioned panels to prevent
  contamination

• All applications with blinding and pegging issues
• Replace Harp and slotted screens for increased wear life and accurate gradations
• Replace square opening wire to gain more production & wear life
• Replace synthetic media to gain production and lower cost per ton

• More Open Area results in more production
  - Poly-Clean S – 12% to 18% increase compared to square woven wire
  - Poly-Clean L – 12% to 30% increase compared to square woven wire
  - Poly-Clean H – 30% - 70% increase compared to square woven wire
  - Even greater performance numbers when replacing Synthetic Media
• Lower cost solution
  - Works better than flexible rubber media
  - Eliminate ball and heated decks
  - Replace expensive Stainless Steel with Ultraloy